For this fun idea you only need three things. They include, duct tape, a leash hook, and scissors. Be sure to measure your tape and leash hook before you start as they all come in different sizes. Note: these leashes have not been tested on dogs that pull. use with caution
- Cut a length of tape 60 inches long (152.4 cm for those of you over seas or anywhere that isn’t the US)
- Lay the tape on a flat surface, sticky side up.
- Seeing that you have already measured the leash hook, fold one side of the duct tape to match the length of the leash hook (the part that connects to the leash, not the end that connects to the dog) and make sure there are no bumps.
- Repeat step 3 with the other side that you have not folded in to the middle.
- Insert one end of the duct tape into the leash hook and fold it back at least 2 inches (5.08 cm).
- Cut a 3 inch (7.62 cm) piece of duct tape and place it over the fold that you made in step 5
- Flip over the leash so the sticky side of the 3 inch (7.62 cm) piece of tape is up and seal the edges making sure to line up the patterns if you have one on your tape.
- create a loop at the other end of the leash for your hand. and repeat steps six and seven for this loop.
parts of this idea were borrowed from
- Sew Doggy Style. Sew Doggy Style. 14 August 2013. Blog. 8 April 2017.
If you live in the warm climates, like I do, then you know this can be a fun time for the mosquito population and fleas to attack your pup. The mosquitoes could spread deadly heartworms and the fleas can cause internal parasites and much discomfort.
To avoid these costly issues, you could spend an arm and a leg at the vet on some flea control and heartworm prevention which trust me, is not easy to give. Or you could go the natural route and try some lavender oil.
Lavender oil (fleas) and peppermint oil (mosquitoes) are found to repel mosquitoes and fleas for a couple days. If applied properly, your pup should be flea and mosquito free.
To make the special concoction you will need:
- 2 ounces of distilled or boiled water
- 1.5 ounces of witch hazel
- and 50-75 drops of the lavender oil and peppermint oil
Mix them all together in a 4 ounce clean spray bottle and can be sprayed on your pooch’s collar or on the dog. This product should be applied every few days to keep the pests away.
WARNING: DO NOT USE THIS ON CATS!!
Information from http://tasty-yummies.com/homemade-essential-oil-insect-repellent-spray/?m
What you will need:
- a large container
- some of your dog’s favorite toys (make sure they are water proof)
- a freezer
How to make this fun popsicle:
- gather all of the ingredients listed above
- put the water in the container and place the toys in the water
- place the container with the toys and water in the freezer and allow it to sit for 2-3 hours (if not completely frozen place it back in the freezer for a little longer)
- give it to your pup and watch him/her go to work on getting the toys out of the ice block
idea and image from: http://barkpost.com/3-dog-toys-you-can-make-from-things-around-the-house/
It’s that time of year again, seeing the relatives, easter egg hunts, and all the fun that goes along with it. So, why not include the dog in on the fun.
What you will need:
- Plastic eggs
- dog treats
- willing participants
Set up: First, you will want to fill the eggs with the yummy treats. Next, place the eggs around your backyard. Then, let the dogs loose to find them. It will be entertaining for you and them.
During this time of year water bottles seem to be in large supply around the house. Why not put them to good use and make a simple cat treat dispenser to make your kitty happy.
What you will need:
- a water bottle
- an x-acto knife
- your kitty’s favorite treats
How to make this toy:
- gather up all of the items needed
- using the x-act knife make holes in the water bottle large enough so the treats can fit through them, but not too large though.
- place the treats in the bottle and give it a shake
- watch your kitty come running for it.
- If you have a creative side you can decorate it and make it your very own
It should look like this when finished:
You can also do the same basic idea with a round container, some non-toxic glue, an x-acto knife, and treats.
- Using the x-acto knife cut holes in the sides of the container you are working with (holes big enough for the treats to fit through).
- Glue the lid to the container to the bottom of it and let it dry for a few minutes
- Once the glue has set, add some treats to the inside of the bowl and let it roll.
Here is a basic idea of what it should look like as a guide:
These lovely ideas were presented to us by: